ignition lock

One after the other , insert the keys into the ignition lock , switch the ignition on and establish communication with the control module .

将钥匙逐一插入点火锁，启动点火开关并与控制单元建立通信。

Insert the key in the ignition lock cylinder and turn the ignition switch to the On position .

将钥匙插入点火锁柱中，旋转点火开关到开启的位置。

Remove the vehicle key from the ignition lock and check whether the radio remote control is working .

将车钥匙从点火锁中拔出，检查无线电遥控是否工作。

Automobile Ignition Lock Matched with Transcoder Key

汽车变码式数码钥匙点火锁

This paper illustrates the necessity of using electronic key ignition lock on vehicles and introduces the structure of the lock and the function of each part .

说明了使用机动车电子钥匙点火锁的必要性，详细介绍了其结构及各部件的功能，着重分析了工作过程；

The output end of the starting gear in the three-gear switch of the ignition lock is connected with a running preparation control relay .

三档点火锁中的启动挡的输出端连接行车准备控制继电器。

Fatigue Test Bench for Motorcycle Ignition Switch Lock

摩托车点火开关锁疲劳耐久性测试台的研制

The test bench equipped with 8031 one-chip computer can be used for the test of ignition switch lock at random times and can tell the operating times , position and number of contact points of the switch when trouble happens ;

测试台采用以8031单片机为核心的测试装置，对车锁可作任意次数的测试，并能随时检测出发生故障时的开关次数、档位及触点数；

Turn the ignition switch to the LOCK ( 0 ) position .

转动点火开关到锁（0个）位置。

When working on the ignition system , the ignition key must be removed from the ignition lock .

对点火系统进行作业时，必须将点火钥匙从点火锁上取下。

Taking the transistor ignition coned device of the SANTANA CAR as an example , the paper describes the construction , working principle and operational process of the ignition lock matched with transcoder key .

以普通桑塔纳轿车的晶体管点火控制装置为例，阐述了变码式数码钥匙点火锁的结构、工作原理及工作过程。